Bikeman Performance Polaris RZR Pro R Stage 4 Bolt on Performer Kit

Bikeman Performance Polaris RZR Pro R Stage 4 Bolt on Performer Kit

Features:

• All new stainless steel slip on exhaust
• Clutch Kit with sniper weights with springs
• Cyclone clutch cover (Cools belt up to 30 degrees)
• Air extreme head ported intake
• Custom tuned Brain crower cams
• .430 lift drop in cams
• +1 over sized valves or +1 over sized valves
• Our performance clutch springs hold much better belt tension then factory
• More responsive feel
• Gains top speeds and low end power
• Must send in ECU for tuning
• Must send in head for core exchange or buy out the head for 2400$
• Head must include original cam keepers with Numbers matching to head to be a valid exchange. Keepers are bored with the head and are a matching set. Non matching keepers turn head into paperweight.

Notes:

• Pro R HP ratings-
• Stock 230-235hp@8400rpm
• Stage 4, Level 4 ECU tune, Air Extreme Big Valve Head (1mm intake 1mm exhaust CNCP head)/BMP.430 lift cams, BMP muffler - 312hp8750rpm / 199TQ@7575rpm

Notes:

These steps are different than the service manual. Do not follow service manual steps. Steps for starting your Pro R stage 3 and above for the first time.

• Roll the engine over by hand at least 10 revolutions clockwise when looking at it from the rear.
• Check Cam timing to make sure it is correct
• Make sure coolant and oil is at the correct level.
• Start the engine and hold above 2000rpm until it reaches 170 degrees F.
• Using the throttle drop rpm 50 rpm per 30 seconds until idle seems unstable.
• Stay at the unstable rpm until it becomes stable and then repeat step 5.
• Once the machine is idling at 1450 stable with no throttle input let sit and idle for 10-15 minutes.
• Your machine is now ready to ride.
• On higher duration cams it is common to need to give a little throttle to start the vehicle this is completely normal