Bikeman Performance Polaris RZR Pro R Stage 3 Bolt on Performer Kit

Bikeman Performance Polaris RZR Pro R Stage 3 Bolt on Performer Kit

Features:

• .430 lift drop in cams
• Bikeman custom spec from Brian crower
• Instant throttle response
• Low end grunt and top end pull with the cams
• Choppy idle people Will turn heads over
• Our performance clutch springs hold much better belt tension then factory. Clutching adjusts to any terrain
• More responsive feel
• Cyclone clutch cover for even cooler belt temps and longer belt and clutch life
• Gains top speed and low end power
• These cams are specific to us and none Else can buy this same cam profile. Brand new cores not a regrind camshaft
• Must send in ECU for hard flash

Kit Includes:

• Slip on exhaust free flow exhaust
• Sniper weights with springs
• Cyclone clutch cover
• ECU hard flash
• Custom .430 lift cams

Notes:

These steps are different than the service manual. Do not follow service manual steps. Steps for starting your Pro R stage 3 and above for the first time.

• Roll the engine over by hand at least 10 revolutions clockwise when looking at it from the rear.
• Check Cam timing to make sure it is correct
• Make sure coolant and oil is at the correct level.
• Start the engine and hold above 2000rpm until it reaches 170 degrees F.
• Using the throttle drop rpm 50 rpm per 30 seconds until idle seems unstable.
• Stay at the unstable rpm until it becomes stable and then repeat step 5.
• Once the machine is idling at 1450 stable with no throttle input let sit and idle for 10-15 minutes.
• Your machine is now ready to ride.
• On higher duration cams it is common to need to give a little throttle to start the vehicle this is completely normal.